- RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA UPDATE
- RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA DRIVER
- RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA UPGRADE
Please note, this is not a downloadable upgrade, but a software disc that needs to be purchased from an authorised Icom dealer.
RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA UPGRADE
Users who already have the RS-BA1 Version 1 can upgrade to the Version 2. The RS-BA1 Version 2 can also still be used with single receiver transceivers.
The RS-BA1 Version 2 can also enlarge the panel size (normal or large is selectable), buttons added, clickable indicators to change settings, SUB dial added and RIT tuning knob & TX functions added. With the RS-BA1 Version 2, you can use the dualwatch operation and spectrum scopes with waterfall function as well as observe the MAIN and SUB spectrum scopes. Allowing you to remotely operate a selected transceiver from another room or remote location, the RS-BA1 Version 2 along with the RC-28 makes a great accessory to compliment your Amateur transceiver. RS-BA1 Version 2 is the latest software of the previous RS-BA1. Note for RS-BA1 Version 1 users: To obtain the new features in the RS-BA1 Version 2, the purchase of the new software package is required.RS-BA1 Version 2 IP Remote Control Software
RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA DRIVER
RS BA1 VERSION 2 IP REMOTE CONTROL SOFTWA UPDATE
Note: Depending on your transceiver, some functions or modes cannot be used, or you need to update the transceiver’s firmware. * A static public IP address or Dynamic DNS is required for the base station (Server) PC, when you configure the remote control system through the Internet. You can use the transceiver installed in another room using your home network, or even from a remote location over the Internet*. The RS-BA1 Version 2 offers real-time operation with low latency, high quality audio. Low Latency, High Quality Audio Over an IP Network
The following functions are added to the RS-BA1 Version 2. Most functions and modes of your transceiver, including interference rejection functions and IF filter settings, can be controlled using the CI-V commands. The spectrum scope functions (single receive) are usable with the IC-7300. * The dualwatch and dual spectrum scope functions are only for the IC-7851, IC-7850 and IC-7610. MAIN and SUB spectrum scopes can be observed on the RS-BA1 Version 2 at the same time. The dualwatch operation and dual spectrum scopes with the waterfall functions* can be used on your remote PC. Incorporating the RS-BA1 Version 2 software, the RC-28v.2 comes complete with remote control USB encoder and will work with the IC-7100, IC-7200, IC-7300, IC-7410, IC-7600 & IC-9100 via USB, and with the IC-7610, IC-7700, IC-7800, IC-7850 & IC-7851 via an ethernet cable. The RC-28 IP Remote Control System, allows Radio Amateurs to remotely operate selected Icom amateur transceivers. The RS-BA1 offers real-time operation with low latency, high-quality audio allowing you to use an Icom radio installed in another room using your home network, or even from a remote location over the Internet.Ī new version of this software is now available called RS-BA1 Version 2 which will allow users to take advantage of some of the features of HF radios such as the IC-7610, IC-7851 and IC-7850 including dualwatch operation and dual spectrum scope. The RS-BA1 remote control software gained popularity by allowing Amateur radio operators to operate selected Icom radios from a PC via IP.